1800W 40A ZVS Induction Heating Board Module Flyback Driver Heater+Tesla coil+fan

Specifications:Name: ZVS Induction Heating Board ModuleProduct size: 180mm x 90mm x 80mm (Manual measurement, error about 3mm, please understand)Heater ring inner: 70mm (Recommended crucible + quartz suit, maximum support of 58mm crucible)Input voltage: 12V-48V recommend: 36V abovePower requirements: less than 12V10A , 15V above15AMaximum power: 1800WMaximum current: 40AFeatures:- This products maximum power 1800W, adopted super PCB layout design and super heat sink, heat dissipation good, since with a cooling fan interface, can also do Tesla discharge, generator voltage inverter, etc..- This induction heating circuit uses 12-48V low voltage DC power supply, maximum current 40A, the most highest power is 1800W. It can work continuously under the condition of good heat dissipation. Due to its moderate power, it can be used by DIY players to give smaller players the parts can be treated by quenching, annealing and other heat treatment. You can also be melted with graphite crucible Kim, Silver, Copper, aluminum and other metal, heating evenly, is fast and very convenient.- In this test, the maximum power is close to 1600W, and the maximum current is 35A. This product is available at under the condition of good heat dissipation, the utility model can work continuously for hours.Note:1. The power of heating is very large, except that the plate and components are hot, and the heat of copper tube is very high. The buyer can prepare water cooling system separately, can buy a small wa